| ||||
|
| |||
Refines the default domain defined by a constrained Delaunay
triangulation without seeds into a mesh satifying the criteria
defined by the traits criteria. The domain of the mesh
covers all the connected components of the plane defined by the
constrained edges of t, except for the unbounded component. Precondition: The template parameter CDT must be a model of the concept ConstrainedDelaunayTriangulation_2. The geometric traits class of the constrained Delaunay triangulation must be a model of DelaunayMeshTraits_2. Requirement: The face of the constrained Delaunay triangulation must be a model of the concept DelaunayMeshFaceBase_2. Criteria must be a model of the concept MeshingCriteria_2 and CDT::Face_handle must be the same as Criteria::Face_handle. | ||||
| ||||
|
| |||
Refines the default domain defined by a constrained
Delaunay triangulation into a mesh
satifying the criteria defined by the traits
criteria.The sequence [begin, end]
gives a set of seeds points, that defines the domain
to be meshed as follows. The constrained edges of
t partition the plane into connected components.
If mark=true, the mesh domain is the union of
the bounded connected components including at least
one seed. If mark=false, the domain is the
union of the bounded components including no seed.
Note that the unbounded component of the plane is
never meshed. Requirement: The value_type of begin and end is CDT::Geom_traits::Point_2. |